Tabla de contenido
Idiomas disponibles
Idiomas disponibles
s
5. seRvICe
s
a) Have your power tool serviced by a qualified
-
repair person using only identical replacement
l
parts. This will ensure that the safety of the power
tool is maintained.
e
g
g
IV - Additional safety rules
h
for cordless drills / drivers
s
e
▪ Be aware that this tool is always in operating condi-
t
tion, because it does not have to be plugged into an
y
electrical outlet. Always set the trigger switch to the
locked OFF position when installing or removing the
-
battery pack.
▪ If possible, always use clamps or a vice to hold your
f
work.
▪ Do not touch the bit after operation. It will be very hot.
r
▪ When using the drill, use safety equipment including
s
safety glasses and ear defenders. Wear a dust mask
-
if the drilling operation creates dust.
▪ The dust, separated while processing materials, con-
f
taining quartz (SiO
-
not process materials containing asbestos.
.
▪ The tool must be used only for its prescribed purpose.
-
Any use other than those mentioned in this Manual
will be considered a case of misuse. The user and not
the manufacturer shall be liable for any damage or in-
jury resulting from such cases of misuse.
t
▪ To use this tool properly, you must observe the safety
t
regulations, the assembly instructions and the oper-
e
ating instructions to be found in this Manual. All per-
sons who use and service the machine have to be
s
acquainted with this Manual and must be informed
-
about its potential hazards. Children and frail people
d
must not use this tool. Children should be supervised
at all times if they are in the area in which the tool is
e
being used. It is also imperative that you observe the
l
accident prevention regulations in force in your area.
-
The same applies for general rules of occupational
-
health and safety.
e
▪ The manufacturer shall not be liable for any changes
made to the tool nor for any damage resulting from
-
such changes.
h
Even when the tool is used as prescribed it is not pos-
e
sible to eliminate all residual risk factors. The following
e
hazards may arise in connection with the tool's construc-
tion and design:
t
▪ Damage to the lungs if an effective dust mask is not
s
worn.
e
▪ Damage to hearing if effective ear defenders are not
e
worn.
s
V - Additional instructions
y
s
for work with the charger
s
▪ Before using the charger, read all the instructions and
-
cautionary markings on the charger and battery pack
d
as well as the instructions on using the battery pack.
l
▪ Only charge your batteries indoors as the charger is
d
designed for indoor use only.
Original instructions
RS-754-1924-pages-BR2 10.8Li.indd 5
) is dangerous to your health. Do
2
WARNING: (For UK, Ireland, Cyprus or Malta
only):
Your RS cordless power tool is supplied with a char-
ger, which is fitted with a standard CEE 7/16" Euro
plug. In order for you to safely use this charger in the
UK, Ireland, Cyprus or Malta, you will need to fit the
enclosed converter plug. Not using the supplied con-
verter plug may invalidate the warranty.
The converter plug encapsulates an Euro plug, giving
a permanent/semi-permanent conversion to a British
plug. Please see instructions (Fig. 6) at the front of the
manual before fitting this converter plug.
▪ Place the adapter plug flat side down on the work sur-
face, using the correct screwdriver (either flat head or
Philips) unscrew the central retaining screw. Turn over
the adapter plug and carefully lift the cover of the plug
to reveal the inside of the adapter.
▪ Insert the 2 pin CEE 7/16 Euro plug into the retaining
clips of the adapter plug as shown on Fig. 6 and care-
fully close the cover of the adapter plug. Turn the plug
over, to reveal again the central retaining screw and
carefully tighten the screw, making sure the two sides
of the adapter plug fit together.
▪ Your adapter plug is now complete and is ready to
use in a BS 1363 electric socket as shown. Please
note you should never remove and type of plug from a
socket by pulling the cable, you should always remove
by gripping the plug itself.
WARNING: If the battery pack is cracked or
damaged in any other way, do not insert it in the char-
ger. There is a danger of electric shock.
WARNING: Do not allow any liquid to come
into contact with the charger. There is a danger of
electric shock.
▪ The charger is not intended for any use other than
charging the exact type of RS rechargeable battery
pack as supplied with the charger. Any other use may
result in the risk of fire or electric shock.
▪ The charger and battery packs supplied with it are
specifically designed to work together. Do not attempt
to charge the battery pack with any other charger than
the one supplied.
▪ Do not place any object on top of the charger as it
could cause overheating. Do not place the charger
near any heat source.
▪ Do not pull on the lead of the charger to disconnect it
from the power source.
▪ Make sure that the charger cord is positioned where it
will not be stepped on, tripped over or otherwise sub-
jected to damage or stress.
▪ Do not use an extension cord unless it is absolutely
necessary. The use of an improper extension cord
could cause the risk of fire or electric shock.
▪ Do not use the charger if it has been subjected to a
5
EN
8.6.2012 . 15:09:08 .
Capítulos
Tabla de contenido
