Identifying Multiplex Channels (2 > Identify) - Promax TVHUNTER Manual De Instrucciones

USER'S MANUAL. TVHUNTER.
4.3.2 Identifying multiplex channels (2 > IDENTIFY)
Once the transmitting source has been detected (by localising a power
maximum), you should check if the received signal corresponds to anyone of the test
points memorised.
1.- Select the identification function 2> IDENTIFY by pressing the key
2.- The key
way (Figure 12.-). Therefore, the test point changes every time that you press
this key. To select a specific test point, press repeatedly this key until the
display shows the name assigned to the desired point. Each time you press
shortly this key it advances to the next Test Point. If you press longer (1s) this
key it goes back to the previous test point. If you want to go to the first Test
Point (TP1) you should press the key
10/2010
Figure 11.- DETECT function.
[2] enables you to change the selected test point in a sequential
Figure 12.- Rotation of active test points.
[1] for 1s.
[2].
Page 19