Seatbelt; Using The Wheelchair; General Functions; Description Of Control Functions - B+B Terra Manual De Instrucciones

TERRA/TERRA SX
| Electric Wheelchair

3.5.7. Seatbelt

The seatbelt is attached to the side of the backrest.
• Adjust the length of the seatbelt by positioning the buckle
accordingly (fig. 11).
• Fasten the seatbelt with the latch.
• Open the seatbelt by pushing the red button at the latch.
11

4. Using the Wheelchair

After adjusting the wheelchair to your personal needs, familiarize
yourself with the control functions.

4.1. General functions

4.2. Description of control
functions
The Terra model with lighting system (fig. 13) is equipped with the VR2
joystick controller with light.
The Terra SX model variant without a lighting system (fig. 14) is
equipped with the VR2 joystick controller without light and only
supplied for export (outside of Germany).
44
Electric Wheelchair |
13
Battery Status Display (fig. 15)
The battery status display shows to what extent the batteries are
charged. If the indicator is within the green range, you have enough
battery power available. If the indicator is within the red range, only
short drives are possible and the batteries should be recharged (see
charging procedure).
ON/OFF Button (fig. 16)
Pushing this button will put your wheelchair into operational mode.
12
Speed Range Display (fig. 17)
The speed range display shows you the pre-selected speed range.
You can set the speed between level 1 and 5, with the corresponding
number of LEDs lighting up. The speed range indirectly tells you the
maximum speed possible at full deflection of the joystick, i.e. with level
5 you can reach the maximum speed possible, while level 1 will keep
you within the lowest speed range.
Setting the Speed Range (fig. 18)
These buttons allow you to increase (right) or decrease (left) the
maximum speed possible. Within each range you control the speed
with the joystick.
Bischoff & Bischoff GmbH |01.06.2019
TERRA/TERRA SX
14
15
16
17
18
45