Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
7. Bevel cutting procedures
Indicator
Fig. 23
WARNING:
8. Miter cutting procedures
Angle Scale
Grade Scale
Indicator
Miter
Scale
18
(1) Loosen the clamp lever and bevel the saw blade to the left.
(2) Adjust the bevel angle to the desired setting while watching
Bevel Angle
Scale
(3) Follow the procedures indicated in paragraphs 5 and 6 above.
Loosen
Clamp Lever
Tighten
When the workpiece is secured on the left side of the blade, the short cut-off portion
will come to rest on the right side of the saw blade. Always turn the power off and let
the saw blade stop completely before raising the handle from the workpiece.
If the handle is raised while the saw blade is still rotating, the cut-off piece may
become jammed against the saw blade causing fragments to scatter about danger-
ously.
When stopping the bevel cutting operation halfway, start cutting after pulling back
the motor head to the initial position.
Starting from halfway, without pulling back, causes the safety cover to be caught in
the cutting groove of the workpiece and to contact the saw blade.
(1) Loosen the side handle and adjust the turntable until the indi-
a
(2) Re-tighten the side handle to secure the turntable in the de-
(3) The miter scale (Fig. 24) indicates both the cutting angle on the
Miter Scale
Fig. 24
(4) The gradient, which is the ratio of the height to the base of the
(5) Therefore, to cut a workpiece at a grade of 2/10, set the indicator
Fig. 25
Turn the
turntable
Loosen
Side Handle
Tighten
Fig. 26
the bevel angle scale and indicator, then secure the clamp le-
ver.
For maximum dimensions for bevel cutting of up to 1-25/32"
(45mm) in height and 12" (305mm) width.
cator aligns with the desired setting on the miter scale (Fig. 26).
sired position.
angle scale and the gradient on the grade scale.
triangular section to be removed, may be used for setting the
miter scale instead of the cutting angle, if desired (see Fig. 25).
to position a as indicated in Fig. 24.
NOTE:
* Positive stops are provided at the right and left of
the 0° center setting, at 15°, 22.5°, 31.6°, 35.3° and
45° settings.
Check that the miter scale and the tip of the indica-
tor are properly aligned.
* Operation of the saw with the miter scale and indi-
cator out of alignment, or with the side handle not
properly tightened, will result in poor cutting preci-
sion.
Tabla de contenido
