Light Emitting Diodes (Leds) On Analyzer; Diagnostic Software - Stihl ADG 2 Manual De Instrucciones

Light Emitting Diodes (LEDs)
on Analyzer
The light emitting diode (1) on the
analyzer can glow or flash green, yellow
or red.
Green continuous light
Cordless power tool or function in
–
order.
Yellow continuous light
Intermittent fault in cordless power
–
tool in the past (e.g. loose contact),
power tool ready for operation at the
moment – the fault can be called up
in the power tool's fault memory.
Red continuous light
Active fault in cordless power tool,
–
power tool is not ready for operation
at the moment – a fault code is
displayed.
Problem – see "Troubleshooting"
–
Red flashing light
... may mean the following:
Observe safety information on
–
display
Fault in analyzer (analyzer's display
–
remains blank) – software update
required.
ADG 2

Diagnostic software

STIHL diagnostic software can be used
only with the MDG 1, ADG 1 and ADG 2
analyzers.
System Requirements
1
Install STIHL diagnostic software only
on a computer that meets the system
requirements. You must have
administrator rights to install the
software on a computer running
®
Microsoft Windows
system administrator if necessary.
Operating System
®
Microsoft Windows
–
®
Microsoft Windows Vista
–
®
Microsoft Windows
–
Software Requirements
®
Microsoft .NET 3.5 or higher
–
®
Adobe Acrobat
–
higher
Hardware Requirements
Minimum requirements
CPU 1 GHz
–
256 MB free memory
–
minimum of 100 MB hard disk
–
space
Resolution – SVGA monitor
–
(minimum resolution 1024 x 768)
USB interface 1.1 or higher
–
CD-ROM or DVD drive
–
Recommended configuration
–
–
–
–
–
–
®
, contact your
®
XP SP 3 or
®
or
®
7
®
Reader 9 or
CPU 2 GHz
512 MB free memory
minimum of 100 MB hard disk
space
Resolution – SVGA monitor
(minimum resolution 1024 x 768)
USB interface 1.1 or higher
CD-ROM or DVD drive
English
9