Hardware Installation - D-Link DUB-1312 Guía De Instalación Rápida

PRODUCT SETUP

HARDWARE INSTALLATION

Step 1:
plug the duB-1312's usB cable into an available usB port on your computer. If available, you
should use a usB 3.0 port in order to achieve the fastest possible transfer speeds.
Step 2:
attach an ethernet cable to the ethernet port on the duB-1312.
Step 3:
attach the other end of the ethernet cable to your network switch, hub, or router.
Step 4:
Windows will detect the new hardware and prompt you for the drivers.
For Windows 7 and Vista:
the driver software installation will start automatically.
For Windows XP:
the Found new Hardware Wizard box will pop up. select Yes, this time only and click
Next to continue.
on the next screen, choose the option to install the software automatically and click
Next to continue. the driver software installation will then start automatically.
INSTALLATION COMPLETE
When the installation of the duB-1312 is complete, the lInk led should be solid green, indicating a
good physical connection between the duB-1312 and the network, and will flash when data is being
sent or received. the connection speed led will light solid to indicate a Gigabit connection, or remain
unlit to indicate a 10/100 mbps connection. If both leds are unlit, there may be a problem with the
physical connection. check the cables between your duB-1312, the computer, and the network. Verify
that your network switch, hub, or router is powered on.
Number
1
2
4
1
Indication Status
Solid
Connection Speed
Off
Solid
Link/ACT
Flashing
2
Description
1 Gbps connection present
10/100 Mbps connection present
An active connection is present
Data is being transmitted/received
DUB-1312