Troubleshooting - Musical Fidelity M6x ViNYL Manual De Usuario

MM / MC
x ViNYL
PHONO STAGE

Troubleshooting

Problem Probable Cause
No power. Power plug is not inserted into
socket correctly.
No sound. Wrong connections between
input sources and the unit
Cartridge incorrectly wired.
Sound too quiet/loud. Wrong MM/MC cartridge
selection.
Sound is not precise, Cartridge incorrectly wired.
lacking in bass and
stereo image.
Input connector plugs not fully
pushed in.
Output connector plugs not fully
pushed in.
Hum. Turntable not earthed or needs
earthing.
Turntable already earthed and
earthing
further creates hum loop in
system.
Earth loops already in system
being amplified.
Audio connector plug not fully
pushed in
Cable fault.
Unsuitable Cable
(e .g . cable grounds not
connected).
Pop or click heard in High gain of M6x
speakers ViNYL, amplifying
when switching on or normal circuit
off or transients.
changing options.
Distorted sound. Cartridge and/or tone arm not
aligned properly.
Cartridge fault or worn needle.
Dirt on record.
Distorted and loud Line outputs of M6x ViNYL
sound. plugged into PHONO amplifier
inputs of following amplifier.
If none of these actions affect a cure, please contact the dealer, or an authorised Musical Fidelity
service agent.
Remember; never open the case of the M6x ViNYL, as this will invalidate the warranty.
8
Remedy
Plug in securely into unit's IEC socket.
Check audio input and output lead connections.
Check cartridge wiring.
Use MM setting for MM cartridges.
Use MC setting for MC cartridges.
Check turntable tracking weight and cartridge setup.
Check plugs are inserted fully and securely.
Check turntable earthing lead is connected to earthing post.
Disconnect earthing lead from earthing post.
Investigate for earth loops elsewhere in system.
Insert plug securely and check cable is connected at both ends.
N .B . some esoteric cables have internal wiring intentionally disconnected/
modified. For best results on all inputs AND outputs, please use good
quality screened coax; fully connected signal-to signal, screen-to-screen.
Not a fault. It is recommended that the volume level on amplifier is turned
down if switching the M6x ViNYL on or off; or pressing option switches
whilst connected.
Carefully follow turntable instructions to correctly re-align tone arm and
cartridge.
Replace needle or cartridge.
Clean dust and dirt from record.
Use LINE level inputs only, e.g. an AUX input.