Input Selection; Operation - Musical Fidelity M6x ViNYL Manual De Usuario

Operation

Once the M6x ViNYL unit is correctly wired up, and
plugged into mains, the orange STBY led should
be lit.
In this mode the M6x ViNYL is consuming a
minimal amount of power.
To switch the unit on, press the Power button (1)
on the front of the unit. The blue PWR indicator
will light along with the red MUTE indicator. After
a few seconds, when it has stabilised, the MUTE
function will switch off and the unit is ready for
use.
MM/MC selection
Press the MM/MC button ( 2 ) to switch between
MM/MC cartridges.
MM loading
Press the MM loading button ( 3 ) to cycle through
MM loading.
IEC
Press the IEC button ( 4 ) to reduce the subsonic
output of the phono amplifier caused by disk warp
and turntable rumble.
Gain
Press the +6db button ( 5 ) to increase the output
gain.
MC loading
Press the MC loading button ( 6 ) to cycle through
MC loading.
Note: A great deal of effort has gone into
making sure that the unit exhibits no loud
noises through the system during switching
options or on/off. However, once installed
into a hifi system, it is still a very high gain
(amplification) amplifier at the beginning
of a high amplification chain. Therefore,
increasing the main amplifier volume to
maximum and listening for clicks/thumps is
neither recommended nor sensible. It is
strongly recommended that the option
buttons are only pressed when the volume
is turned down (or muted), to avoid any
accidental loud transients getting through to
the speakers. Once options are set, the
volume should then be turned back to normal
listening level.

Input selection

The M6x ViNYL has a total of three phono inputs
available.
From the front panel you can cycle through the
inputs by using the ◄ and ► buttons (7). Pressing
► while on input 3 will cycle back to input 1.
Whilst on input 1 the ◄ button will take you to
input 3 again.
When each input is selected, the M6x ViNYL will
remember the last settings applied.
Outputs
On the rear of the unit are 2 sets of outputs.
RCA (single ended) and XLR (balanced). Both
can be used simultaneously. XLR (balanced) is
recommended for greater dynamic range and
lower noise, while RCA (single ended) is
recommended for compatibility with other devices.
You can connect the M6x ViNYL to your amplifier
using whichever is more convenient.
Ground lift switch
LIFT - Signal ground is disconnected the from
chassis ground.
SOFT - Signal ground is via a resistor and a
capacitor connected to chassis ground. Low
frequency hum can be blocked effectively,
whereas radio frequency interferences are
conducted to ground.
DIRECT - Signal ground is connected to chassis
ground.
7