Starting The System; Unit Confi Guration Via Console; Change Operation Mode - S&P CTB ECOWATT Instrucciones De Uso

L L anguage:
E E NGLISH OK
OK
After choosing the language, a screen with the following information will appear:
S S i:xxxPa x%
S S c:100Pa C:1
Si: xxx Measured value (units depend on operation mode)
Sp/Sc: xxx Set point programmed
X% Fan speed in % (on high speed))
C: 1 Fan number if connected to network
Pressing the button can access the second screen of information:
R R PM:xxx InD:0
R R ele:0 C:1
RPM: xxx Fan speed (TACOM terminals connected is required)
Rele: 0 It Indicates if the alarm output relay is connected (0: offl ine output; 1: output connected)
InD: 0 Digital input (J11 night mode or Min/Max)(0: offl ine output; 1: output connected)
C: 1 Communication cannel used (de 1 a 247)

6.5. STARTING THE SYSTEM

Once done the wiring and confi guration of existing units, proceed to the system power supply.
When connecting the unit, it will appear the initial screen with Software version, after 3 seconds will initiate the connection
with number of memorized unit. If communication is successfully, it will appear the fi rst information screen. Corresponding
screen of PI PRESSURE mode will appear by default:
6.6. UNIT CONFIGURATION VIA CONSOLE

6.6.1. Change operation mode

Once the unit is powered, desired language selected and showing screen described above, continue with following sequence:
Idioma:
CASTELLANO
PI PRESSURE/COP mode
Si: 100 Pa 100%
S S i:100 Pa 100%
Sp: 100 Pa C:1
S S p:100 0 Pa a C:1
PROPORTIONAL/VAV mode
S2: 30%HR 21%
S S 2: 30%HR 2 2 1%
C:1
C C :1
Langue:
FRANCAISE
PI VOLUME/CAV mode
3
Si: 100 m /h 100%
S S i:100 m3/h 100%
3
Sp: 100 m /h C:1
S S p:100 0 m3/h h C:1
MIN-MAX mode
IN_D:ON 21%
I I N_D:ON 2 2 1%
C:1
C C :1
39
Sprache:
DEUTSCH