Installation Requirements - Zanussi ZHC4284 Manual De Instrucciones

Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a
All installations must comply with the local authorities requirements for the discharge of exhaust air.

Installation Requirements

gas.
extraction (ducted to the outside) or recirculation mode.
The manufacturer disclaims any responsibility for damage due to incorrect installation of the cooker hood or if the
hood is not installed in compliance with relevant regulations controlling this type of installation.
Unpacking
Before unpacking the cooker hood position the carton
with the arrows pointing upwards as illustrated on the
carton.
The cooker hood is made up of the following com-
Ref. Q.ty Product Components
1 1 Hood Body, complete with: Controls, Light,
Blower, Filters
2 1 Upper Chimney
7.1 1 Telescopic frame complete with extractor,
consisting of:
7.1a 1 Upper frame
7.1b 1 Lower frame
9 1 Reducer Flange ø 150-120 mm
10 1 Ø120-125mm collar
13 1 Gasket
14 1 Hood Body Air Outlet Extension Piece
15 1 Air Outlet Connection
25 Pipe clamps (not included)
26 1 Fixing Part of the upper Chimney
29 1 Air outlet connection tube
Ref. Q.ty Installation Components
12c 4 Screws 2,9 x 9,5
12f 2 Screws M6 x 15
12q 4 Screws 3,5 x 9,5
12w 2 Screws M3 x 8
21 1 Drilling template
22 4 6.4 mm int. dia washers
24
2
Fixing knobs for the air outlet connection piece
Q.ty Documentation
1 Instruction Manual
GB
INSTALLING THE COOKER HOOD
12w
7.1a
7.1
7.1b
12c
2
1
12f
22
12q
21
26
13
15
24
14
29
10
9
25
17