First Activation; Installation Rules - Vimar 46264.001.01 Manual De Usuario

46264.001.01

First activation

Run the installation procedure described below:
1) Before installation switch off the power supply to all connected devices to prevent damaging the device.
2) Check that the Ethernet cable and the other cables are correctly connected.
3) Connect the PoE IN port of the PoE Ethernet repeater to the PoE port on the switch, using an Ethernet cable.
4) Connect the PoE OUT port of the PoE Ethernet repeater to a generic PD, using an Ethernet cable.
5) Ensure that each device is intact, check that it has been installed correctly and that all connections are reliable, then proceed to
power up the system.
6) Make sure that the PoE power supply and the network are working correctly.
Troubleshooting
If you find any problems during installation, follow the steps described below:
• Make sure that you have correctly followed the device installation instructions.
• Check that the RJ45 connectors are wired in conformity to industrial standards EIA/TIA 568A or 568B.
• The transmission distance depends on the signal source and the cable quality. Do not exceed the maximum transmission distance.
• Replace a faulty device with a correctly operating one to check if the device is faulty.
• If the problem persists, contact your retailer.
The instruction manual is downloadable from the site www.vimar.com

Installation rules

Installation should be carried out by qualified personnel in compliance with the current regulations regarding the installation of electrical
equipment in the country where the products are installed.
Ensure clearance around the appliance so there is sufficient ventilation.
There must be no dripping or splashes of water on the appliance.
Conformity
EMC directive
Standards EN 60950-1, EN 55032, EN 55035
WEEE - Information for users
If the crossed-out bin symbol appears on the equipment or packaging, this means the product must not be included with
other general waste at the end of its working life. The user must take the worn product to a sorted waste center, or return it to
the retailer when purchasing a new one. Products for disposal can be consigned free of charge (without any new purchase
obligation) to retailers with a sales area of at least 400m
environmentally friendly disposal of the used device, or its subsequent recycling, helps avoid the potential negative effects on the
environment and people's health, and encourages the re-use and/or recycling of the construction materials.
, if they measure less than 25cm. An efficient sorted waste collection for the
2
9