Work HYDROSHOT WG629 Manual De Instrucciones página 10

POSITEC Inc. has established
a partnership with the RBRC
Corporation to recycle any Positec
batteries with the RBRC-call2recycle
seal. For environmental protection,
please do not discard batteries in
the trash. After the batteries' life
cycle is ended, then please call
1-800-822-8837 for a free service
that will properly dispose of the
battery.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY & OPERATION
ACTION
BEFORE OPERATION
Installing the battery pack
Removing the battery pack
Charging the battery pack
10
More details can be found in WA3742's
manual
ASSEMBLY
NOTE: The power nozzle has two
working modes: short lance only
and short lance used together with
extension lance.
Working mode 1
Attaching short lance to the power
nozzle
NOTE: When attaching, align the
two projections on the lance with the
grooves of the power nozzle as shown
in Fig. B.
NOTE: In this working mode, the
highest pressure is 94psi. it is suitable
for light duty cleaning and watering.
Attaching the Multi-spray nozzle
NOTE: When attaching, rotating the
nozzle left and right to make sure the
nozzle fully seated into position and
gently pulling it to make sure it is
locked into position securely.
20V Max Lithium Portable Power Cleaner
Working mode 2
Attaching extension lance to the power
nozzle
Attaching short lance to the extension
lance
NOTE: When attaching, align the
two projections on the lance with the
grooves of the power nozzle as shown
in Fig. D, E.
NOTE: In this working mode, the
highest pressure is 320psi. it is suitable
for removing strong stains.
Attaching the hose to the power nozzle
NOTE: After the hose is attached, check
the connection by gently pulling upon
the hose. It should not be pulled off.
Attaching your own water hose
(optional)
1. Remove the hose adaptor
2. Attach the home garden hose with
suitable connectors
NOTE: Except for the hose supplied,
you can also connect the power nozzle
FIGURE
to your own water hose with suitable
connectors.
NOTE: When retightening the quick
See Fig. A1
hose adapter, please tighten securely.
Otherwise, it may not draw any water
See Fig. A2
for proper operation.
OPERATION
See Fig. A3
Pressure setting
Your power nozzle has two pressure
modes.
Start
NOTE: At the first use, you need to
empty the air in hose, place the
power nozzle below waist level
(<5ft/1.5m), then attach the extension
lance and set it at high pressure. Do not
start working until the water
See Fig. B
goes up along the hose and sprays out.
This could take up to 30
seconds or more depending on the
fresh water source.
Selecting the nozzle pattern
NOTE: Choose a suitable nozzle
pattern according to your work. Spray
patterns 0
applicable for cleaning, and the spray
pattern with the symbol
suitable for watering.
See Fig. C
WARNING: Do not shift the
nozzle pattern when the tool is
powered on.
o o o o
, 15 , 25 and 40 are
is best
See Fig.
D, E
See Fig.
F1, F2
See Fig.
G1, G2
See Fig. H
See Fig. I
See Fig. J
EN