Switching The Input Signal - Eizo FlexScan HD2442W Manual Del Usuario

Prior to use
Using the Operation Switch
Operation switch
• There are three methods of
operation:
- Touching the switch
- Tapping the slide bar
- Tracing the slide bar
• The operations with the slide
bar (selecting, setting, adjusting,
fixing and deciding items) can be
performed with the remote control.
* When the signal is not input,
even if the contents of the menu
have been changed, the menu of
"Volume" is displayed.
Installation Setting/Adjustment
 Turning the power On/Off
Power On: Touch any of the keys to turn on the monitor.
 Switching the Input Signal
Tap
 Displaying/Quitting a menu
Shortcut menu
Touch the slide bar.
(When the menu is not displayed on the screen)
By touching the switch for 5 seconds, the contents of the menu changes
as follows: "Volume" → (touching for 5 seconds) →"Color Mode" →
(touching for 5 seconds) → "Brightness".*
 Selecting a menu item/Setting and Adjusting
Trace the slide bar left and right.
At fine adjustment
Tap either end of the slide bar, marked with
Tapping once changes the adjustment value to one step up or down.
Touching the slide bar continuously may change the value serially.
 Fixing an item
Deciding the setting and adjusting value
Tap the slide bar.
Troubleshooting
Power Off: Touch
Each time you tap the switch, the
input signal switches to the other.
Setting menu
Touch
The increase/decrease speed of the
adjustment value may change
depending on the tracing speed of the
slide bar.
and .
.
.
7