Operating Mode Selection - Manusa Visio Manual De Instrucciones

DUSI01EN - v5
3.4– OPERATING MODE SELECTION
To change the operating mode, use a program switch and proceed as indicated below.
DOOR OPEN
The door will open. With the door in open position, the leaves
can be moved manually.
DOOR CLOSED
In doors without automatic lock, this operating mode will close
the door and let the doors free. In doors equiped with an
automatic lock, the leaves will lock and remain blocked.
REMARK: to ease the exit of people, during the closing cycle
the leaves will reopen if the inside detector or push button is
activated. After reaching the open position, the door will close
again until they close fully.
* When necessary, an authorized Technical Service technician may configure
the door to delay the activation of the automatic lock, to allow the user reach
the door and exit before the leaves get blocked by the automatic lock.
AUTOMATIC DOOR
The door will open every time an activation device (interior or
exterior) is triggered.
EXIT ONLY
The door will only open when an interior activation device is
triggered..
NOTE: if the door is equipped with an automatic lock, the door
leaves will remain blocked while they keep in closed position.
AUTOMATIC DOOR WITH VISIO OPERATOR - USER MANUAL
SMART selector
Press buttons 2 or 4 until you see
blinking. Then press 3 to valídate your
selection.
Message OPEN will show on the display.
OPTIMA selector
Press button
OP will show on the display.
SMART selector
Press buttons 2 or 4 until you see
blinking. Then press 3 to validate your
selection.
Message CLOSE will show on the display.
OPTIMA selector
Press button
CL will show on the display.
SMART selector
Press buttons 2 or 4 until you see
blinking. Then press 3 to valídate your
selection.
Message AUTOMATIC will show on the
display.
O P T I M A
Press button
AU will show on the display.
SMART selector
Press buttons 2 or 4 until you see
blinking. Then press 3 to valídate your
selection.
Message EXIT ONLY will show on the
display.
OPTIMA selector
Press button
EO will show on the display.
18
on the selector.
on the selector.
selector
on the selector.
on the selector.