Stove In Operation; Burner Cleaning; Modify The Air Fan Speed; Turning Off The Stove - Bio Bronpi Berta Instrucciones De Instalación, Uso Y Mantenimiento

8.3.2

STOVE IN OPERATION

The hot air fan will start working when the smoke temperature reaches a minimum. Once the ignition phase is finished, the stove will pass to
the working model, which represents the normal operating mode. Each power is shown on the display with the lighting of 2 leds as shown on
drawing D22.
For instance, in case of selecting Power 3 the display will light up 6 leds. In case of choosing Power 6 the display will light up 12 leds until a
maximum of 24 leds that means Power 12.
8.3.3

BURNER CLEANING

While the stove is working normally, automatic cleaning of the
burner takes place in 30 minutes intervals. This process consists
on cleaning the rest of pellet remaining in the burner in order
to guarantee a proper operation of the stove and it takes 30
seconds. During the cleaning all the leds will light up blinking as
shown in drawing D23.
8.3.4

MODIFY THE AIR FAN SPEED

While the stove is working normally, we can change the working air fan speed. By pressing the display during 1 second it will show the same
image as in drawing D24.
By rotating the display clockwise it increases the fan speed, while if we rotate the display counter clockwise we will decrease this speed.
8.3.5

TURNING OFF THE STOVE

To turn off the stove you must only press the display button for 3
seconds. Once it has been turned off, it will start the final cleaning
stage, in which the pellet supply stops and the smoke extractor
will work at maximum speed. This stage does not finish until the
stove has reached the appropriate cooling temperature. In this
moment all the display leds will light up and only one of them will
light off in each lap (see drawing D25).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Blue
Red
Blue
Red
Blue
Red
Blue D24
Red
21
D21
D22
Blue
Red
MOD. BERTA
D23
D25