Getting Started - Bushnell 260224 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21

GETTING STARTED

Installing Batteries
This device operates on two AA batteries. To install, remove the battery compartment cover located on the bottom of the unit.
Insert the batteries into the compartment so that the positive (+) and negative (-) terminals of the batteries match the markings
on the battery cover. Replace the battery cover.
Use and Testing
This device operates on two AA batteries. Make sure it has been installed according to the instructions above.
If you wish to test your night vision device in a lighted area, be sure the objective lens cap (1) is covering the objective lens
prior to pressing the "ON" button (2). The objective lens cap has a pinhole opening to admit a small amount of light for
testing purposes.
If testing or using the device in the dark, remove the objective lens cap and activate the device by pushing the "ON"
button.
Your Night Vision device offers a Built-In Infrared Illuminator (3). This allows you to see in complete darkness where no
ambient light source, such as moonlight, is available. To activate, simply press the button located next to the "ON" button
(4).
Direct the device at an object at a distance approximately 100 yards and rotate the eyepiece (5) to give the best quality
image. After the adjusting, do not rotate the eyepiece any longer irrespective of the distance and other conditions.
Direct the device at the subject to be viewed and adjust the final focus by rotating the objective lens (6) until the image quality
is optimal.
The Green LED indicates that the unit is on (7). Always remember to turn the unit off when done. Do not store this device
while the indicator is lit.
6
Tabla de contenido
loading

Este manual también es adecuado para:

260224w26-0224

Tabla de contenido