Introduction; Equipment; Technical Data; Installation - ESAB COOL 2 Manual De Instrucciones

GB
2

INTRODUCTION

Cooling unit COOL 2 is intended for cooling water-cooled MIG/MAG welding guns.
ESAB's accessories for the product can be found on page 31.
2.1

Equipment

The cooling unit is supplied with an installation instructions and instruction manual.
3

TECHNICAL DATA

Power consumption
Cooling power
Noise
(Constant sound pressure when idling)
Coolant
Coolant quantity
Maximum water flow
Max pressure lift for torch Q
Operating temperature
Transportation temperature
Dimensions lxwxh
Weight empty
Enclosure class
The cooling unit is rated 500 A at 60% duty cycle at 77°F (25°C) ambient temperature.
Enclosure class
The IP code indicates the enclosure class, i. e. the degree of protection against penetration by solid
objects or water. Equipment marked IP23 is designed for indoor and outdoor use.
4

INSTALLATION

The installation must be carried out by a qualified electrician.
CAUTION
This product is intended for industrial use. In a domestic environment this product may
cause radio interference. It is the user's responsibility to take adequate precautions.
4.1

Location

Position the cooling unit such that its cooling air inlets and outlets are not obstructed.
4.2

Power supply

The cooling unit is supplied from the power source, see page .
bk12de
COOL2
40 V AC / 2A, 50/60 Hz
1 kW
< 70 dB (A)
ready mixed (see accessories on page 31)
4.5 l
1.8 l/min
4.6 bar
max
-10° to +40°C
-20° to +55°C
680 x 330 x 230 mm
15 kg
IP23
- 22 -
© ESAB AB2013