Installa On And Pre Opera On; Installa On; Pre Opera On; Opera On - Skyfood BMS Manual De Instrucciones

2. Installa on and Pre Opera on

2.1 Installa on

The Milk Shake Mixer must be installed on a clean and stable surface with a preferen ally
height of 850mm.
This equipment was developed to be used at 110 Volts or 220 Volts (50 Hz ~ 60 Hz).
Before to start the machine, check the voltage on the label existent on the cord. The
voltage shall match the electricity network voltage.

2.2 Pre Opera on

What to do and what not to do with your Milk Shake Mixer.
You have to:
2.2.1 - The network voltage must be the same as the one specified on the label located in
the back of the Milk Shake Mixer.
2.2.2 - The suppor ng surface must be clean and dry.
2.3.3 - Put the liquid ingredients inside the cup before to put the paste or the powder, etc.
You should not:
... expect your Milk Shake Mixer to replace a blander, it does not triturate products, only
mix liquids and pastes or liquids and powders.

3 - Opera on

3.1 - To start the machine

Start the machine by turning ON/OFF switch N° 09 (Pic. 01) to ON posi on, located on the
Motor Housing Lid N° 03 (Pic. 01).

3.2 - Feed Procedure

Remove the Cup N° 05 (Pic. 01) from the Cup Holder N° 02 (Pic. 01), li it then pull it out
and all the way down the sha un l it is totally free. First of all place the liquid (i.e. milk)
inside the Cup and then, introduce the paste (i.e. ice-cream) or the powder (i.e. powder
chocolate).
Then place the cup on the Cup Holder and switch on the Milk Shake Mixer.
The average processing me is 1(one) minute. Therefore, it is not necessary to keep your
equipment turned on any longer.
6 27