HJM HRV608 Instrucciones De Uso página 18

Hervidor Agua HRV608_Maquetación 1 11/08/15 09:21 Página 18
BEFORE USE FOR THE FIRST TIME
Clean the appliance thoroughly to remove any manufacturing resi-
dues.
When using the jug kettle for the first time boil three jugs of water,
and dispose of
theboiled water.
Tip: You can use vinegar or special descaling agents for the first
time.
USE
1. Turn the jug so that the spout faces away from you.
2. Press the button to open the lid (4).
3. Fill the jug with the required quantity of water (at least 0.5 litres,
and a maximumof 1.7 litres). Never fill the water boiler over the
"max". Otherwise the hot water can spatter out of the base.
ATTENTION
Make sure that you do not spill any water on the base.
4. Close the jug's lid by pressing it until it clicks into place.
5. Place the jug on the base, and insert the plug in the wall socket.
Push down the On/Off switch. The On/Off pilot light will illuminate.
6. The jug kettle is now switched on, and the water will now begin to
heat. The jug kettle switches off automatically a few seconds after
the water has come to the boil. The On/Off pilot light will now extin-
guish.
7. Remove the jug from the base by the handle, and pour the water
out.
ATTENTION
Be carefull you do not contact the hot water. It can cause serious bur-
ning wounds.
8. When you wish to heat the water without it coming to the boil you
can switch off the jug kettle at any time you require.
9. Remove the plug from the wall socket when you have finished
using the jug kettle.
- 18 -