Low Battery Warning; Power Management - THERM PRO TP-65S Manual De Instrucciones

Low battery Warning

If the battery power for the base station or remote sensor is low, there will
be low battery icon showing on the upper half area or the lower half area
of the base station display.
EN
If the low battery icon for base station is displayed, please replace the
batteries with new ones.
If the low battery icon for remote sensor is displayed, please charge the
remote sensor as soon as you can.

Power Management

Base station: open the battery compartment of the base station and insert
two "AAA" batteries with correct polarity.
Remote sensor: A built-in rechargeable lithium battery is installed in the
remote sensor. Although there could be some power in the rechargeable
battery before the unit leaves the manufacturing facility, it is always
advised to fully recharge the remote sensor before use by following the
steps below:
1. Connect the charger to the charging socket located on the back of
remote sensor;
2. Plug the charger into a standard AC outlet;
3. The red light on the remote sensor will light up;
4. Charge it for at least 4 hours until the light changes from red to
which indicates charging is complete.
Synchronize Remote Sensors with The Base Station
1. Place the remote sensor near the base station;
2. Once the batteries are installed in the base station, the RF indicator
(located on the upper left of the base station display) will flash for 3
minutes, indicating that the base station is in synchronization mode:
waiting for remote sensors to be registered.
3. Press and hold ON/OFF button on the back of the remote sensor for 2
seconds to turn on the remote sensor. Then wait for a moment until the
green
-6-
temperature of the remote sensor displays on the base station which
indicates that synchronization is complete.
4. If the synchronization is not successful after 3 minutes when the
batteries are installed in the base station and the RF indicator
longer flashes, press and hold the CHANNEL/SYNC button on the left
bottom of the base station LCD display for 3-4 seconds until the RF
indicator flashes again indicating it's back in synchronization mode;
5. Set the CHANNEL selector (on the back of the remote sensor unit) to
position 1 or 2 or 3. The unit is pre-set on Channel 1 and you can
always leave it unchanged unless you have purchased more than 1
remote sensor.
6. If you have additional remote sensors, repeat the above steps to
synchronize the additional remote sensors (up to 3 remote sensors
can be registered with one base station). Please note the additional
sensors should be set to a different channel.
7. If you have registered more than one sensor, press the CHANNEL/
SYNC button on the base station to select the remote channel you
want displayed permanently on the base station. Press CHANNEL/
the
SYNC button until you observe a circular arrow on the base station
LCD display under the channel number, then the unit will auto-scroll,
changing from channel to channel every 5 seconds.
Place the Base Station and Remote Sensor
1. The indoor base station (receiver) should always be placed in a well
ventilated indoor area and located away from vents, heating or cooling
elements, direct sunlight, windows, doors, or any other openings.
2. The remote sensor (transmitter) can be placed on a flat surface either
indoors or outdoors. Make sure the sensor is within the wireless
distance from the base station and with minimal obstructions. Although
the remote sensor is designed to be rain-proof, it still must be always
put in a dry place to avoid direct rainfall.
3. The base station and remote sensor can both be wall mounted.
-7-
no
EN