Care & Cleaning - Summer Infant BABBLE BAND Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
S P E C I AL FE ATUR ES:
• Digital Technology: The Band and Baby Unit are paired for security reasons. The monitor functions on a digital
signal, providing a private and secure connection at all times.
• Power Save Mode: When using Audio mode, the band will go into Power Save Mode to conserve battery after
3 minutes. When noise is detected, audio will turn on and remain on for 3 minutes. After 3 minutes, the band will
go back into Power Save Mode to prolong battery life. If noise persists after the 3 minutes is up, it will go silent
for 3 seconds then audio will turn back on for another 3 minutes.
NOTE: the 3 second pause is not a defect. It is listening for noise to activate audio if needed.
• Rechargeable Battery: The band features a rechargeable battery. Normal use will provide up to 8-hours of use
before charging is necessary.
• Out of Range Alert: If the band is too far from the baby unit, it will be "out of range" and emit 2 consecutive
beeps. The beeps will continue until the band is moved back in range.
• Low Battery Alert: If the band is low on battery power, it will also emit 2 consecutive beeps. The low battery
beep will continue until the unit is charged.
• Locate Band Function: If the band is lost or misplaced, turn off the baby unit. The band will then emit 2
consecutive beeps. The band must be on and battery charged in order to locate.
C ARE & CLE AN IN G:
Step 1: Switch off before cleaning.
Step 2: Remove the monitor from the Band by pushing it out from the bottom.
Step 3: Wipe clean with a damp cloth or sponge. Wipe dry or air dry. Do not immerse in water.
Step 4: Do not use Babble Band if band is still wet. Ensure it is dry before placing monitor unit back onto strap.
Step 5: Push monitor unit back into Band from below. Make sure to align the dots located on the bottom of the
band before use.
P R OB LE M SO LVI N G:
No sound coming from the Band
• Make sure the Baby Unit is plugged in and switched on.
• Make sure electrical outlet is working.
• Set volume to a higher setting.
• Make sure the battery in the Band is fully charged.
Squealing Noise
• Move the Band and Baby Unit farther apart, the squealing sound indicates the units are too close together
• Turn down the volume on band.
Weak reception or no reception
• Make sure both Band and Baby Unit are on.
• Move the Band closer to the Baby Unit.
• Make sure the battery in the Band is fully charged.
Consecutive beeping from Band
• Check to see if Baby Unit is on and has power. Green power on LED will indicate Baby Unit is ON.
• Move within range of Baby Unit to establish a connection.
• If sound is coming from Band and beeping continues then battery is low. Place Band on Baby Unit to charge.
Tabla de contenido
loading

Productos relacionados para Summer Infant BABBLE BAND

Este manual también es adecuado para:

29556

Tabla de contenido