BATTERY BACK-UP
(For Temporary Time Storage Only)
Install (2X AA/ LR6/ UM-3) battery (not included) according to polarity shown inside
the battery compartment. In the event of a power interruption, your set will not work
normally from the mains supply but there is now the advantage that your clock will
continue to work. The clock display will not light up, as the clock time will be held
in the memory. This also enables you to move the set from place to place without
re-setting the clock every time. The battery back-up system is only meant to be used
from short temporary power interruption. For longer durations the battery may
become exhausted or there may be some deviation in accuracy. When the battery is
exhausted, it should be removed from the set to prevent leakage. If you do not wish
to take advantage of the battery back-up system, your set will work normally without
a battery. However, if disconnected from the mains, the clock figures will flash
when the mains are re-connected and you must re-set the clock as described in the
Electronic Clock Operation paragraph.
Attention should be drawn to the environmental aspects of battery disposal. Don't
throw used batteries in dustbin. Please contact your retailer in order to protect the
environment.
Attention should be drawn to the environmental aspects of battery disposal.
Electrical products should not be disposal of with household waste. Please recycle
where facilities exist. Check with your Local Authority of retailer for recycling device.
(Batteries pack or batteries installed) shall not be exposed to excessive heat such as
sunshine, fire or the like.
SPECIFICATION
Power Source:
Tuner Range:
Power Consumption:
USB Charging power:
Product information is subject to change without prior notice.
PRODUCT DISPOSAL
Attention should be drawn to the environmental aspects of battery disposal. Don't
throw used batteries in dustbin.
Please contact your retailer in order to protect the environment.
Electrical products should not be disposal of with household waste.
Please recycle where facilities exist.
EN
AC 100-240V~50/60Hz
FM 87.5-108.0MHz
≤0.5W
DC 5V 1A
18