Specific Safety Instructions; Saw Features; Specifications; Unpacking - Brutus 61024BR Instrucciones De Funcionamiento

SPECIFIC SAFETY
INSTRUCTIONS
1. Ensure that the directional arrow marked on the
blade corresponds with the rotational direction of
the motor.
2. With the saw disconnected from the power supply,
rotate the blade by hand to ensure it is free from
obstruction.
3. Always keep the blade-securing arbor and collars
clean.
4. Ensure that the blade-securing bolt is securely
tightened.
5. Never try to cut freehand. Always ensure that the
tile to be cut is pressed firmly against the rip guide.
6. Ensure the material being cut off has sufficient
room to move sideways. Failure to do so may result
in the off-cut binding against the blade.
7. Never cut more than one tile at a time.
8. Never cut pieces too small that are not held securely
against the rip guide, and provide enough space for
the hand to be a safe distance from the blade.
9. Ensure that the table and surrounding area are
clear with the exception of the tile to be cut.
10. Before cutting a tile piece, let the saw blade run
freely for a few seconds. If it makes an unfamiliar
sound or vibrates excessively, switch it off
immediately and disconnect it from the power
supply.
11. Let the blade reach full speed before beginning
the cut.
12. Let the blade come to a complete stop before
removing any jammed material from around the
blade area.
13. Never allow the blade to run dry. Failure to keep
the water tray at the recommended level will result
in possible over-heating of the diamond blade.

SAW FEATURES

• Removable rear water collection tray
• Adjustable cutting head performs plunge cuts and
22.5° and 45° bevel cuts
• 10 in. diamond blade cuts tile up to 2-3/8 in. thick
• Maximum rip cut length up to 24 in. tile
— diagonally cuts up to 18 in. tile
• Folding saw stand with wheels offers quick set up, as
well as easy mobility

SPECIFICATIONS

• Motor: 120 Volts~60 Hz, 9.5 Amps, n
• Blade: 10 in. capacity, 5/8 in. arbor
• Size: 40 in. L x 21.5 in. W x 48.3 in. H (with stand)
• Weight: 105.8 lbs (with stand)

UNPACKING

Open carton from the top.
Top tray contents:
• Table extension
• 10 in. diamond blade
• Upper frame wheels
• Water pump
• Rip guide
• Cord collecting hanger/tool caddy with blade
wrenches (2) and 6 mm Allen key
• Bag of miscellaneous hardware [includes drain plug,
wheel hardware (2), motor frame mounting screws (3),
hardware for mounting tool caddy (2), and motor
frame locking knob]
• User's manual
Middle tray contents:
• Saw stand
Bottom tray contents:
• Motor head assembly
• Saw frame, including attached table and water tray
• Rear water collection tray
ASSEMBLY & SET UP
STEP INSTALLATION AND OPERATION INSTRUCTION
MANUAL. PLEASE READ THE INFORMATION
THOROUGHLY PRIOR TO USING YOUR TILE SAW.
A. STAND SETUP
The stand is ready to use. Simply unfold it as shown
in FIGURE 4.
Place the saw frame on the stand and tighten the stand
knobs for safety (FIGURE 5). You may need to move
or remove water tray to easily secure safety knobs to
stand frame.
– 5 –
3450 RPM
0
THE FOLLOWING IS STEP-BY-