After Treatment - SKINERA IPL 100k Instrucciones De Uso

Decide if you wish to treat the area by Gliding or Pulsing (refer to
5.
section "8.3 Pulsing and gliding").
6. Apply the treatment surface to the skin (#5 in the diagram). Make sure
EN
that the skin is spread evenly and smoothly. When the treatment
surface is in full contact with the skin, the ready light will start blinking
slowly.
7. The device will first determine the colour of your skin automatically
and it will flash a pulse of light onto your skin. You will feel a mild
sensation of warmth and tingling, and you may hear a popping sound.
M
The device will not operate if your skin tone is too dark for safe
use.
M
If you are pulsing, remove the device from your skin. The
device will immediately recharge for the next pulse. After a few
seconds (depending on the energy level) the ready light will
turn on again, and will pulse when pressed against the skin.
8. If you are pulsing, repeat the process. If you are gliding, simply continue.
9. Continue to pulse or glide until you have treated the area fully.
E
Stop use immediately, if your skin blisters or burns.

10. After treatment

When you have finished your treatment session:
1. Turn the device off by giving the control button an extended press.
Remember the last energy level setting you used, because it will not
be restored when you turn the device on again.
2. Remove the adapter from the electrical outlet.
14