ICON AIRFRAME PRO Manual Del Usuario página 5

4 E E 5
CHINSTRAP
In order for your helmet to function properly, the chinstrap must always be securely fastened while in use. With the chinstrap
fastened, it should not be possible to remove the helmet from your head by pulling up at the center rear. Check periodically to see
that the vibration has not caused the chinstrap to loosen. Just give a little tug to make sure it is still tight.
1
To securely fasten the D-ring retention system, thread the end of the chinstrap through the D-rings only as shown in the diagram
below. Fasten the female snap of the chinstrap to the male snap to secure the loose end of the chinstrap after the chinstrap is
securely fastened. The only function of the snap fastener on the end of the chinstrap is to keep it from flapping in the air stream. It
is not part of the retention system and should not be used independently without passing through the D-rings as illustrated below.
To release the D-ring retention system, unsnap the loose end of the chinstrap from its fastener. Then pull on the red flag attached
to the end of the lower D-ring to loosen the strap. Once loose, feed the end of the strap back through the D-rings to fully release
the chinstrap.
Please make sure that the chinstrap is fastened as instructed above. Failure to do so may result in fatal injury.
SAFETY WARNING: Do not rely on the snap to secure the helmet. The snap is provided only to prevent the strap from flapping in
the air. Fasten the retention system only in the following manner of the picture.
AIRFRAME PRO SHIELD
The Airframe Pro is equipped with the Icon Optics™ precision shield, providing you with an unequivocally clear and distortion-
free line of sight. All Icon Optics™ shields include the exclusive Rapid Release™ system for the easiest shield removal and
replacement on the market. Icon® shields are available in a variety of tints and styles; perfect for any riding situation you
may find yourself in.
The Icon Optics™ shield supplied with this helmet meets Regulation VESC-8. Visors with the marking indicating "daytime use
only" are not suitable for use during the hours of darkness or in conditions of poor visibility. Make sure the face shield is
always in perfect condition.
The Icon TracShield™ is available for the AIRFRAME PRO as a factory solution for riders who prefer tear-offs. Compatible with
our Rapid Release™ shield change mechanism, the TracShield™ can be used on the AIRFRAME PRO and Airmada helmets,
and is available in Dark Smoke, Clear, Yellow, and RST Silver. Tear-offs are available separately.
SHIELD CHANGE AND REMOVAL
1. To remove the shield, open the shield completely.
2. Push both locking levers to the open position toward the rear of the helmet
and remove the shield from the gear plates.
3. Once removed, brace the shield with one hand, and use the other hand to
pull the side plates from the straight, long edge (the front of the side plates).
4. Pull each side plate until they pop free from the shield.
5. To replace shield, align the tabs on the shield with holes on the gear plates
and press in until secure.
6. To replace the side plates, align tabs on side plate with holes in shield, and
snap it into place. Repeat for adjacent side plate.
7. Test the opening and closing function of your shield before riding.
6
2 3
1 2
3 3 4
E E 5
6
1
2
4