Rough Slicing Pieces; Slicing - Auxilab Nahita ZFP010 Manual De Instrucciones

Turn the tightening screw of the microtome knife clockwise, evenly support the microtome
knife and be not tight-ened first.
Forwards and backwards move and turn the tightening screw of the microtome knife, and
adjust the rear angle of the microtome till the expected position ( between 0-10 degrees of the
tool carrier angles).
Clockwise turn the tightening screw of the microtome knife and evenly tighten the microtome
knife
Clockwise turn the locking bolt to tighten to the rear angle

6.4 rough slicing pieces

Screw the gripper of stopping slices and loose the wax-lump forceps, turn the handwheel to
fall the specimen till the corresponding position with the microtome knife.
Loose the handle of fixing the tool carrier, move the tool carrier and make the cutting edge
close to the specimen and then lock the handle of fixing the tool carrier.
Turn the clutch of bracing tooth and make the bracing tooth be out the ratchet.
Turn the ratchet round to move the specimen, carefully adjust the specimen till it meets with
the microtome knife exactly. At the same time turn the handwheel to make the specimen
move up and down, and watch the distance of the specimen to the cutting edge,
simultaneously trim the specimen wax-lump levelly.
Turn the handwheel to make the specimen move to the highest position turn the clutch of
bracing tooth to make the bracing tooth coincide with the ratchet.
Turn the adjuster of thickness till the thicker degree turn the handwheel round to try slicing
the specimen till the expected specimen surface carrier the tool carrier can simultaneously
move on all sides. The forward and backward moving can move the tool carrier to the right
slicing position, and the moving towards the left and right can make the whole length of the
cutting edge of the blade be fully utilized and unnecessary to adjust the other positions of the
blade.

6.5. Slicing

Through turning the adjuster of thickness, adjust the slice thickness to the expected value.
Evenly turn the handwheel to slice
Take the slices to produce the specimens.
Attention; you should turn the handwheel evenly, and the velocity of the turning must fit in
with the hardness of the specimen when you slice the harder specimen, it should be slower.
19
Manual de instrucciones-Instruction manual Versión-Version 2017