Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4
3
ASSEMBLY INSTRUCTIONS
MOUNT DRUM LID (FIG. 2)
Drum lid is mounted onto the bottom of
blower housing assembly. To mount drum lid:
1. Carefully lay blower housing assembly up-
side down (on motor) on a card- board cov-
ered flat surface.
2. Attach chip deflectors and inlet hub to
bottom and top of drum lid as shown using
hex head bolts, lock washers and hex nuts.
Fig. 2
Inlet hub.
Chip
deflector.
3. Attach lid cylinder to lid using hex head
bolts, lock washers and hex nuts.
4. Position blower gasket on bottom of
blower housing assembly so that five holes
are aligned.
12
1
5. Position top of drum lid on top of blower
gasket so that five holes are aligned.
6. Secure drum lid to blower housing assem-
bly using hex head bolts, flat washers and
2
hex nuts.
7. Secure cylinder guard to cylinder using
self-tapping screws.
8. Make sure that all screws, bolts and nuts
are secure.
NOTE: Carefully place the unit right-side up
on the drum or container.
be overturned if bumped. Place unit on a
clean, level surface.
ATTACH ELBOW (FIG. 3)
The 90° elbow is attached to the outlet
guard. To attach the 90° elbow:
1. Position the 90° elbow onto the out- let
guard and align the four holes.
2. Secure the 90° elbow to the outlet guard
using self-tapping screws. To attach hose:
ATTACH HOSE
Blower
1. Slide hose clamp onto free end of hose.
housing.
Loosen clamp screw if required to slide hose
clamp onto hose.
2. Position the hose clamp wires on the hose
grooves.
3. Slide hose with clamp onto 90° elbow.
4. Tighten hose clamp screw to secure hose.
Blower
ATTACH NOZZLE
gasket.
Nozzle is attached onto remaining end
hose. To mount nozzle:
1. Place hose clamp onto one end of hose,
Drum lid.
loosen clamp screw if required to slide hose
clamp onto hose.
2. Slide connector side of nozzle all the way
into hose.
3. Position hose clamp approximately 1"
Cylinder.
from end of hose and tighten securely.
Cylinder
ATTACH FILTER BAG
guard.
Refer to Figure 4.
The filter bag is attached onto the 90° elbow.
To attach filter bag:
1. Slide bag clamp over bag inlet.
2. Slide bag with clamp onto 90° elbow.
3. Secure bag to 90° elbow by tighten- ing
bag clamp.
WARNING: This unit is top heavy and can
of
Tabla de contenido
