Cleaning And Maintenance; Technical Specifications - Velleman PCMP32 Manual Del Usuario

2. Place the solar charger in direct sunlight, the solar panel facing the
sun.
3. The green solar charging LED will light to indicate the solar charger is
charging.
7. Charging an External Device
Refer to the illustrations on page 3 of this manual.
1. Check the charging status of the solar charger. To do so, press the on-
off button once. See table above for power status. Press the on-off
button again to switch off.
2. Connect your device to the solar charger using the included USB cable.
3. Disconnect the device when it is charged.
Remarks:
 For best results, it is advisable to fully charge your solar charger prior to
use it as a device charger.
 The solar charger will automatically switch off when using the solar
charger and its battery is very low, this in order to protect the internal
battery from excessive discharge. In this case, the solar charger will
only switch on after 3 minutes of charging.
 Do not overcharge the solar charger: only charge the solar charger via
USB once the power status has reached 75 %.
8. Using the Torch
Your solar charger has an integrated torch. Quickly press the on-off button
twice to switch the torch on or off.

9. Cleaning and Maintenance

The PCMP32 does not need any particular maintenance. However, it is
advisable to clean it occasionally to keep it looking like new.

10. Technical Specifications

battery
capacity
solar charging
colour
material
input
V. 05 – 15/12/2016
PCMP32
high capacity Li-polymer battery
5000 mAh
5 V / 200 mA
green
ABC + PC
5 VDC – 1 A
6 ©Velleman nv