Aligning The Camera - Perel WLC003 Manual Del Usuario

5.5 Peripheral Connection
You can allow the camera to transfer the video signal to an external
monitor or a television.
1. Connect the camera to a monitor using the included AV cable.
2. Switch on the monitor and set it to AV mode.
3. Switch on the camera and proceed to test the system.
4. Once connection is successful, the camera will enter playback
mode and the screen turns black. The image will be shown on the
monitor.
6. Operation
6.1 System Setup and Test
1. Slide the mode switch to the TEST position.
2. Press video or capture to switch between these two modes.
3. Press menu to enter or to exit the setup menu.
4. Press up or down to navigate through the menu or options, and
press OK to confirm.

6.2 Aligning the Camera

Set the optimum exposure angle on the camera. Consider whether the
use of the lateral motion sensors may be useful for attaining the
desired observation results. You can activate or deactivate these
sensors at all times.
1. After having installed the camera, switch on the camera and
move slowly from one side of the target area to the other. While
doing this, monitor the motion display.
2. If the LEDs turn blue, you are detected by one of the activated
lateral sensors. If the LEDs red, you are detected by the front
motion sensor. By this way you can align the camera to the best
angle and distance.
V. 01 – 17/06/2020
WLC003
8 ©Velleman nv