Alarm Operation - HAEGER Snoozer RA-06B.005B Manual De Instrucciones

ALARM 2 TIME SETTING
In standby mode,
1. Press and hold AL2 (4) button for about 2 seconds until the hour and minute
digits blink.
2. Press HR (6) button to set the hours.
3. Press MIN (7) button to set the minutes.
4. Press AL2 (4) button again to confirm the alarm 2 time setting (current time
indication returns to the display when finished).
PLEASE NOTE: When operating from batteries only (during back-up mode), the
display will be off and clock will only remain accurate for a short period of time. The
clock accuracy will decrease due to the voltage drop of the back-up batteries. It is
important that the mains supply is restored as soon as possible. If no backup
batteries are installed or the power failure is prolonged, you will need to set the clock
again.

ALARM OPERATION

You can set the radio or buzzer alarms at both preset alarm times in standby mode:
WAKE UP BY BUZZER OR RADIO
1. To set or adjust the alarm time, follow the steps in "CLOCK AND ALARM TIME
SETTING".
2. To set alarm mode (radio or buzzer) or disable the alarm function for ALARM 1,
Press AL1 (3) repeatedly until the desired alarm mode appears on the display.
Each time you press AL1 (3), the alarm indication changes as follows:
No alarm indication (alarm 1 is disabled) →
AL1 radio indicator (15) → No alarm indication (alarm 1 is disabled)
3. To set alarm mode (radio or buzzer) or disable the alarm function for ALARM 2,
Press AL2 (4) repeatedly until the desired alarm mode appears on the display.
Each time you press AL2 (4), the alarm indication changes as follows:
No alarm indication (alarm 2 is disabled) →
AL2 radio indicator (17) → No alarm indication (alarm 2 is disabled)
4. When the alarm time is reached, the radio or buzzer will sound unless the alarm
function is disabled.
Instructions for use
AL1 buzzer indicator (14) →
AL2 buzzer indicator (16) →
English
5