User Instructions - VMB HDT-8 Manual De Instrucciones

Quick operation guide
O R I G I N A L

4. USER INSTRUCTIONS.

4.1 - Place the lift on a fi rm, fl at surface in
the area it is to be used supported with its
transport wheels (T).
4.2 - Remove the outriggers from their
transport supports (S) and fully insert
them into their positions (V) checking that
they are fi xed by the pins (R).
4.3 - Adjust the outrigger stabilisers (Q) by
turning the cranks to level the lift. Ensu-
re it is in a vertical position by using the
bubble level indicator found on the base
section. The bubble should be in the cen-
tre of the circle.
4.4 - Place the forks in a horizontal posi-
tion ready to take the load on them.
4.5 - THE MAXIMUM LOAD IS 350 Kg
(772 lb). The lift should NEVER be over-
loaded (over 350 Kg). Safety at work is
the most important element. Place the
load onto the lift using an adequate sup-
port according to the need, use so that
the weight of the load will only elevate in a
vertical direction.
4.6 - How to place the load: Always load
as close to the tower as possible.
PRO LIFTS S.L.
3.17 - Only original replacement parts should be used.
The maximum load diminishes according
to the distance from the body of the tower
as illustrated in the diagram below, which
shows the load on the gravity centre with
distances to the lifting carriage at a maxi-
mum lifting.
CAUTION
When two towers are used to elevate a
bridge, down truss or many towers to ele-
vate a structure of any type, it is almost
impossible that two or more people co-or-
dinate the winches elevating or lowering
the loads, at exactly the same pace. At a
certain point each tower will be extended
to a height different to that of the others.
For this reason it is necessary that the
structure does not stretch and allows for
these differences.
Depósito legal y copyright 2013. Todos los derechos reservados.
ENGLISH
60 cm / 23,62 in
50 cm / 19,69 in
40 cm / 15,75 in
30 cm / 11,81 in
230 kg / 507 lb
290 kg / 640 lb
350 kg / 772 lb
180 kg / 397 lb
8