Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DOOR REVERSAL (ON SOME MODELS)
The following instructions are applicable for models with side
opening door.
Tools Needed:
Flat-blade screwdriver
Min. 8" long TORX T25
®
screwdriver
You can change your door swing from a right-side opening to a
left-side opening, if desired.
1.
Place a towel or soft cloth on top of dryer or work space to
avoid damaging the surface.
Remove door from dryer cabinet
1.
Open the dryer door.
2.
Using a T25
screwdriver, remove screws (A) and then (B)
®
screws from each of the two hinges that attach dryer door to
front panel of dryer. Set the hinge screws off to the side for
reinstalling the door.
3.
Remove the dryer door by lifting upward and out to lift
the door off the cabinet. Lay the door on a flat, covered
surface,with the inside of the door facing up.
22
Plastic putty knife
#2 Phillips screwdriver
A
B
A
B
4.
Remove the 2 plastic plugs (A) located outside the dryer
door opening.
A
A
A
A
5.
Install 2 plastic plugs (A) into screw holes where the hinges
were removed in Step 4.
Reverse the strike
1.
Remove the door strike (A) from the dryer door opening.
2.
Remove the cosmetic screw (B) opposite the door strike (A).
A. Door strike
B. Cosmetic screw
3.
Reinstall the door strike and cosmetic screw on the opposite
side of dryer door opening from where they were removed.
NOTE: Door strike and plugs must be on the same side of
the dryer door opening.
B
A
Tabla de contenido
