Burner Grates; Sealed Gas Cartridge - JENN-AIR w1017346 Guía De Uso Y Cuidado

S G
EALED
Sealed Burner Cartridge –
Model JGA8150ADB (black)
Model JGA8150ADW (white)
Model JGA9150ADP (pro)
The sealed burners of your cartridge
are secured to the cartridge and are not
designed to be removed. Since the burners
are sealed into the cartridge, boilovers or
spills will not seep underneath the cooktop.
However, the burner caps should be cleaned after each use.
(See page 4 for cleaning directions.)
• The burner caps must be properly positioned before cooking.
TO PREVENT THE COOKTOP FROM DISCOLORING
OR STAINING:
•
Clean cooktop after each use.
•
Wipe acidic or sugary spills as soon as the cooktop has
cooled as these spills may discolor the porcelain.

Burner Grates

The grates must be properly positioned before cooking.
Improper installation of the grates may result in chipping of
the cooktop.
Do not operate the burners without a pan on the grate.
The grate's porcelain finish may chip without a pan to
absorb the heat from the burner flame.
Although the burner grates are durable, they will gradually
lose their shine and/or discolor, due to the high temperatures
of the gas flame.
Installation
TO INSTALL SEALED BURNER
CARTRIDGE:
1. Be sure control knobs are turned
OFF.
2. Clean basin of any grease
accumulation. (See appliance
User's Guide for cleaning
recommendations.)
3. With the back raised, position the burner cartridge with the
mixer tube openings and ignitor rods toward the orifices
and terminal receptacle. Slide the cartridge until the tubes
C
AS ARTRIDGE
and ignitors start to engage, then lower the cartridge so
that it rests on the cooktop surface. Gently slide forward to
fully engage.
TO REMOVE SEALED BURNER CARTRIDGE:
1. Control knobs should be in the OFF position and the
cooktop should be cool.
2. Lift up the edge of the cartridge until the bottom of the
cartridge clears the basin. (Lifting the cartridge too high
while still engaged could damage the ignitor rods and
mixer tubes.)
3. To disengage the cartridge, hold by the sides and pull
away from the terminal receptacle and orifices. Lift out
when fully unplugged.
4. Do not stack cartridges where they may fall or be
damaged.
Notes:
•
A properly adjusted burner with clean ports will light
within a few seconds. If using natural gas, the flame will
be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy, the air/gas
mixture may be incorrect. Contact a service technician to
adjust. (Adjustments are not covered by the
warranty.)
With LP gas, slight yellow tips on the flames are
acceptable. This is normal and adjustment is not
necessary.
•
With some types of gas, you may hear a "popping"
sound when the surface burner is turned off. This is a
normal operating sound of the burner.
•
If the control knob is turned very quickly from High to
Low, the flame may go out, particularly if the burner is
cold. If this occurs, turn the knob to the OFF position,
wait several seconds and relight the burner.
•
The flame should be adjusted so it does not extend
beyond the edge of the pan.
5