ULTRALINK ULM300USB Controls
Model: ULM300M
(2)
Type of product: Wireless Microphone
ULM300USB Controls
1.
USB connector
2.
POWER/STATUS LED
3.
VOLUME UP Button (—Power on/-Volume up/-Unmute)
4.
VOLUME DOWN Button (-Volume down/—Mute/
—Power off from Mute)
NOTE: "—" (long dash) = long press; "-" (hyphen) = short press.
LED Status Key
The following table describes LED behavior on both the microphone and
the USB wireless receiver:
Activity
No Signal
Connected, Active
Connected, Muted
Connected, Active,
Low Battery
Connected, Muted,
Low Battery
ULM300USB Getting Started
1.
Plug the USB wireless receiver to the designated USB socket on
wireless-enabled BEHRINGER mixers, powered speakers or other
compatible products, or to a USB port on a computer. The POWER/
STATUS LED on the receiver will slowly fl ash amber.
2.
Press and hold the VOLUME UP button on the wireless microphone
to switch it on and commence transmission. Both the LEDs on the
wireless microphone and USB wireless receiver will light solid green
once connected.
3.
Once switched on, the wireless microphone will be set at its previous
operating volume level. Use the VOLUME UP and VOLUME DOWN
buttons to adjust the volume.
4.
A long press of the VOLUME DOWN button will put the wireless
microphone into mute. The mute condition is indicated by rapid
green fl ashing of the LED. If the user does not unmute within
10 minutes, the wireless microphone will power down to save
battery life.
5.
A further long press of the VOLUME DOWN button when in mute will
switch off the wireless microphone.
6.
A short press of the VOLUME UP button will unmute the wireless
microphone. When the wireless microphone is unmuted, it will
return to the previous volume level.
NOTE: The connection range between speaker and Bluetooth streaming
device may decrease if Bluetooth streaming and wireless microphones are
used simultaneously.
Model: ULM300D
(3)
(4)
LED Color
Amber
Green
Green
Green/Red
Green/Red
(2)
(1)
LED Behavior
Flashes on/off slowly
Solid
Flashes on/off quickly
Alternating colors
Alternating colors, fl ashes
on/off