ECOVACS ROBOTICS WINBOT X Manual De Instrucciones página 28

6. Troubleshooting
No. Malfunction
The robot's fan doesn't work
after the Safety Pod has been
3
connected with WINBOT and
attached to the window.
Remote Control cannot control
4
WINBOT.
28
EN
Possible Causes
Safety Pod malfunction
WINBOT is in sleeping mode
When WINBOT is cleaning, only the START/
PAUSE Button works on the Remote Control.
The Remote Control is not paired with
WINBOT (WINBOT arrives from the factory
paired with its Remote Control. If the Remote
Control becomes un-paired or is replaced, it
can be re-paired).
WINBOT Status Indicator Light glows a
continuous RED.
The batteries are not inserted in the Remote
Control or need to be replaced.
Solutions
Check the Safety Pod Status Indicator Light on the
WINBOT, and refer to Section 5 for details.
Press the START/PAUSE Button on WINBOT to wake it
up.
Pause WINBOT by pressing the START/PAUSE Button on
the robot or Remote Control. Other buttons on the Remote
Control will function while WINBOT is paused.
Within the first 5 seconds of powering ON WINBOT, press
and hold START/PAUSE Button on WINBOT and Pairing
button on the Remote Control at the same time. Pairing
is complete when START/PAUSE Button blinks RED and
BLUE and beeps.
Press and hold the RESET Button on the Remote Control
to initialize WINBOT, then the Remote Control will
function.
Insert or replace the batteries in the Remote Control.