Section 3. Troubleshooting - TECshow FLATSIX Manual De Usuario

Section 3. Troubleshooting

No response from fixture
when power is applies
Fixture resets but does
not respond correctly to
controller
(DMX mode operation)
Colors cannot be mixed
Fixture does not reset
correctly
No light, lamp cuts out
intermittently,or burns out
too quickly
FLATSIX - LED PAR LIGhT
ENGLISH VERSION
Probable cause(s)
No power to fixture
Primary fuse blown
Secondary fuse blown
Controller not connected
Incorrect addressing of the fixtures
Bad data link connection
Conflict between tracking and vec-
tor control
Data link not terminated
Defective fixture or 2 devices trans-
mitting on link
Random color mixing is on
Electronic or mechanical failure
Lamp missing or blown
Fixture or lamp is too hot
Remedy
Check power cables
Replace fuse
Replace fuse
Connect controller
Check address setting on fixture and controller
Inspect cables and correct poor connections and/or
broken cables.
Eliminate scene cross-fade on controller
Insert termination plug in output of last fixture
Bypass fixtures one at a time until normal operation is
regained:unplug both connectors and connect them
directly together
Turn off random color mixing
Contact service technician
Disconnect fixture and replace lamp
Allow fixture to cool. If problem persists, contact service
technician
p. 7