Machine Connection - TECshow FLATSIX Manual De Usuario

Machine Connection

Cable Connectors
Cables must have a male XLR connector on one end and a
female XLR connector on the other end.
A word on termination: DMX is a resilient communication
protocol, however errors still occasionally occur. Termina-
tion reduces signal errors, and therefore best practices in-
clude use of a terminator in all circumstances. If you are ex-
periencing problems with erratic fixture behavior, especially
over long signal cable runs, a terminator may help improve
performance.
To build your own DMX Terminator: Obtain a 120-ohm, 1/4-
watt resistor, and wire it between pins 2&3 of the last fixture.
They are also readily available from specialty retailers.
• Maximum 8 PCS fixtures connected by Daisy chain connection.
Master-Slave control model:
Set up one fixture as Master fixture(triggering),other fixtures as
slave fixtures(receiving trigger signals).Set up all fixtures same
address value or following DMX controller performance(Atten-
tion: all fixtures use the same DMX channel-7 or 11CH)
FLATSIX - LED PAR LIGhT p. 6
ENGLISH VERSION