Triton Blue 7R Beam Pro Manual De Usuario página 19

I
NSTRUCCIONES DE FUNCIONAMIENTO
1. b
rieF
The light panel diagram show as Figure 3, Left area is TFT Displayer, support touch, and right area is
encoder button, both of touch and coder button can operate light and setting.
Display & operation just like "Android operation system", toach the item will set or modify setting.
Note: Prevent damage the tpuch or TFT displayer, can not use sharp objects chick displayer.
2. o
Peration
• Operate light with touch or encoder button.
» The left area is TFT Displayer and touch, click item or value with finger will to complete
operation of set light setting(parameters) or view light state.
» The area on the right hand side is rotary encoder with button, as auxiliary input interface,
if disable touch function, the encoder can been choose to set or view the item, and then
press the encoder button to confirm the selection, rotary encoder again set the parameter
value, finally. Press encoder button one again to save value or setting.
• Parameter value setting
When the selected item is value need to been modified, the dialog shown in Figure 4 will popup.
Modify Value: Can quickly modify value via pull the slider to the desired position, or click the button of
"up" or "down" with finger on the right side to set the exact desired value, another way is roll encoder on
the right hand side of panel.
Apply Value: When value had been modified, then press the bottom of "apply" in the left corner to apply
to the light, but haven´t saved.
Save Value: Any time, click on the lower right corner of the "OK" button, the setting will been saved into
internal memory.
User Manual | 7R BEAM PRO Triton Blue | Rev. May.2015 | www.triton-blue.com
19.