LG LTG4715 Serie Manual De Preparación página 47

5
Spray or pour the remaining water (8 oz or 240
ml) onto the bottom center of the oven cavity.
The indentation on the oven bottom should be
fully covered to submerge all soils. Add water if
necessary.
nOTE
If cleaning multiple ovens, use an entire bottle
of water to clean each oven. Do not spray water
directly on the door. Doing so will result in water
dripping to the floor.
6
Close the oven door.
Turn the oven mode knob to select EasyClean
Press Start.
CAUTIOn
• Some surfaces may be hot after the
®
EasyClean cycle. Wear rubber gloves while
cleaning to prevent burns.
• During the EasyClean
becomes hot enough to cause burns. Wait
until the cycle is over before wiping the inside
surface of the oven. Failure to do so may result
in burns.
• Avoid leaning or resting on the oven door glass
while cleaning the oven cavity.
7
A tone will sound at the end of the 10 minute
(Lower) / 15 minute (Upper) cycle. Touch
CLEAr/OFF to clear the display and end the
tone.
8
After the cleaning cycle and during hand-
cleaning, enough water should remain on the
oven bottom to completely submerge all soils.
Add water if necessary. Place a towel on the
floor in front of the oven to capture any water
that may spill out during hand-cleaning. If you
are cleaning the upper oven on a double oven
range, it is also best to cover the holes in the top
of the lower oven door with a towel to capture
any water that may drip into the door during
hand cleaning.
® cycle, the oven
9
Clean the oven cavity immediately after the
®
EasyClean
non-scratch scouring sponge or pad. (The
scouring side will not scratch the finish.) Some
water may spill into the bottom vents while
cleaning, but it will be captured
in a pan under the oven cavity
and will not hurt the burner.
nOTE
Do not use any steel scouring pads, abrasive
pads or cleaners as these materials can
permanently damage the oven surface.
®
.
10
Once the oven cavity is cleaned, wipe any
excess water with a clean dry towel. Replace
racks and any other accessories.
11
If some light soils remain, repeat the above
steps, making sure to thoroughly soak the
soiled areas. If stubborn soils remain after
multiple EasyClean
Clean cycle. Be sure that the oven cavity is
empty of oven racks and other accessories,
and that the oven cavity surface is dry before
running the Self Clean cycle. Consult the Self
Clean section of your owner's manual for
further details.
If a self-clean option is not available, scrape off
and remove stubborn soil using a scraper.
nOTE
• If you forget to saturate the inside of the oven
with water before starting EasyClean
CLEAr/OFF to end the cycle. Wait for the
range to cool to room temperature and then
spray or pour water into the oven and start
another EasyClean
• The cavity gasket may be wet when the
®
EasyClean
not clean the gasket.
• If mineral deposits remain on the oven bottom
after cleaning, use a cloth or sponge soaked in
vinegar to remove them.
• It is normal for the fan to operate during the
®
EasyClean
MAINTENANCE
cycle by scrubbing with a wet,
® cycles, run the Self
®
®
cycle.
cycle finishes. This is normal. Do
cycle.
47
, press