Section 3: Programming With Easy-Set Logic - Orbit 28964 Manual Del Usuario

Section 3: Programming with
Easy-Set Logic
™
A note about multiple programs
Your sprinkler timer provides the flexibility of using 2
independent programs (A, B) . The programs are where
you store all of your sprinkler settings . Each program
consists of a group of stations set to specific start
times and run times . Multiple programs allow you to
run different valves on different days with different
run times . While many applications only require one
program (A), using multiple programs (A, B) can be
useful for drip areas, newly planted lawn, or rotary
sprinkler stations . Using programs to group stations
with similar water needs will maximize irrigation
efficiency .
Primary programming can be accomplished in just a
few basic steps .
Primary Programming
Press the [RESET] to clear any previous factory
programming
1. Set Date and Clock
• Turn dial to [DATE/CLOCK] .
• Press the [+/–] buttons to set the current time of day,
then press [ENTER] or [   ] .
7
Tip: To increase or decrease more rapidly, hold down
either the [+] or [-] buttons until the display goes into
rapid advance mode.
• Press the [+/–] buttons to set am/pm, then press
[ENTER] or [   ] .
• Y/M/D will appear (blinking letter indicates selection) .
• Press the [+/–] buttons to set the correct year,
then press [ENTER] or [   ] .
• Press the [+/–] buttons to set the correct month,
then press [ENTER] or [   ] .
• Press the [+/–] buttons to set the correct date .
• Press [ENTER] or turn dial to accept date .
3. Start time
• Turn dial to [START TIME] .
• Press the [+/–] buttons to select time you'd like
your watering to begin . (time will adjust in 1
minute increments)
The display will show