Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8
Touring the RC-SREV1
Turning On & Off the RC-SREV1
Note: In general, set the RC-SREV1 POWER switch to the ON position and use the
SREV1 POWER switch to turn on and off the system. When using a custom-made remote
cable, and an optional AC adapter, if the RC-SREV1 is turned on before the SREV1, the
SREV1 must be turned on within 50 seconds. During this time the message "COULD
NOT COMMUNICATE WITH SREV1. CHECK THE CABLE CONNECTION AND
SREV1'S POWER. THEN TURN ON RC-SREV1 AGAIN." appears. Therefore, turn on
the RC-SREV1 after the SREV1.
To turn on the RC-SREV1, set its [POWER] switch to the ON
1
position.
The startup screen appears, and after communication is established
between the SREV1 and RC-SREV1, the Program page appears.
To turn off the RC-SREV1, set its [POWER] switch to the OFF
2
position.
The RC-SREV1 receives its power from the SREV1 via the remote
cable, so if it doesn't come on, make sure that the remote cable is con-
nected properly and that the SREV1 is turned on.
Using an Optional RC-SREV1 AC Adapter
The remote cable, which carries power from the SREV1 to the RC-SREV1, is 20 meters
in length. Since the power loss in longer cables would be too great, an optional Yamaha
PA-6 AC power supply adapter (12 V DC) is required to power the RC-SREV1 when
using remote cables over 20 meters in length. A wiring diagram for making custom
remote cables is available on page 10. See your Yamaha dealer for more information.
The optional Yamaha PA-6 AC power supply adapter should be con-
nected to the DC 12V IN connector on the rear of the RC-SREV1.
Loop the AC adapter cable around cable clip,
shown here, to prevent accidental disconnection.
Warning: Use only the Yamaha PA-6 AC power
supply adapter with the RC-SREV1. Using any
other AC adapter may cause a fault, leading to a
buildup of heat, fire, or an electrical shock hazard.
RC-SREV1—Owner's Manual
POWER
ON
OFF
DC 12V IN
IN
D C 1 2 V
POWER
DC 12V IN
REMOTE
LCD
BRIGHT
CONT
ON
OFF
Tabla de contenido
