Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
5.
Add fuel to fuel tank.
6.
Connect pressure hose to spray gun and pump.
7.
Connectwater supply to pump.
8.
Attach nozzleextension to spray gun.
9.
Select/attach quick connect nozzleto nozzle extension.
UNPACKTHE PRESSURE WASHER
1.
Remove everything from carton except pressure washer.
2.
Open carton completely by cutting each corner from top
to bottom.
Attach Handle, Accessory Tray, Rope Guide, and
Hose Wrap and Bottle Bracket
1.
Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
3.
Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents, if any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
*
Main Unit
*
Handle
*
Accessory Tray
*
High Pressure Hose
*
Spray Gun
*
NozzleExtensionwith Quick Connect Fitting
*
Oil Bottle
*
Hose Wrap
*
Parts Bag (which includes the following):
*
Operator's Manual
*
Owner's Registration Card
*
Safety Goggles
*
Bottle BracketWireform
.
PerfectMixTM S iphoning Unit/Hose
*
StandardSiphoning Hose
.
Bagcontaining 5 PrecisionSpray
TM
Nozzles
*
HandleFasteningHardwareKit (which includes):
.
Handle Bolts (2)
.
Carriage Bolt (1)
*
Plastic Knobsfor Handle (2)
*
Rope Guide (1)
*
Plastic Knob (2)
*
Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLINGPRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1.
Fill out and send in registration card.
2.
Attach handle and accessory tray.
3.
Connect detergent siphon hose to pump.
4.
Add oil to engine crankcase.
Insert handle carriage bolts (D) through holes from
inside of unit and attach a plastic knob (E) from outside
of unit. Tighten by hand. By loosening both knobs to the
middle section of the attachment bolt, the upper handle
can fold forward to store flat atop the cold engine. Note:
DO NOTfold the handle down while the engine is hot.
Placeaccessory tray (F) over holes (G) on handle
(viewing from back of unit). Push the tree clips (N) into
the holes until they sit flat against the accessory tray.
Insert PrecisionSpray
TM
nozzlesand other supplied
accessories in spaces provided in accessory tray. See
How to Use Accessory Tray.
Tabla de contenido
