Cleaning The Motorized Floor Brush; Checking For Blockages - Shark NV351 Manual De Instrucciones

Rotating
Brush
Fig. 28

CLEANING THE MOTORIZED FLOOR BRUSH

When your motorized floor brush needs cleaning or
locks onto an object, it automatically shuts down to
prevent damage to your lifetime belt. The indicator
light will illuminate red warning you to turn off the
vacuum and clear blockage immediately. The light will
reset itself once blockage has been cleared and power
has been cycled on/off or vacuum has been locked in
the upright position.
1
Detach the motorized floor brush from the
detachable canister.
2
Inspect the opening underneath and the rotating
brush. If a build-up of debris is present, remove it.
Carefully cut anything wound around the rotating
brush with scissors. Avoid damaging or cutting
the bristles. (Fig. 28)
NV351_26_NV352_26_IM_ENG_SPA_101207.indd 15
Make sure you are working in a well
lit area and use a flashlight to help
search for blockages.
Fig. 29

CHECKING FOR BLOCKAGES

Blockages may cause your vacuum to overheat and
shut down. To prevent this from happening, check
potential blockage areas after heavy use or if you
detect a loss of suction or poor cleaning performance.
1 Dust Cup
Dust cup may be full. Empty dust cup.
2
Pre-Motor & Post-Motor Filters
Pre-motor filters require washing every 3 months
for optimum performance. The post-motor HEPA
filter needs to be washed every 2 years..
Ensure that all the filters are clean.
3
Accessories
• Check intake openings:
- Extension Wand
- Dusting Brush
- Crevice Tool
- Turbo Brush
4 Hose and Connections to Vacuum
• Detach the stretch hose from the back of the
detachable canister by squeezing the tabs
together and pulling up. (Fig. 29) Straighten
out the hose and look inside for blockages.
www.sharkclean.com
English
15
10-12-08 9:32 AM