Timer Recording; Setting The Sleep Timer - Aiwa NSX-V50 Manual De Instrucciones

Tabla de contenido
(0
SETTING THE TIMER
To cancel timer standby mode temporarily
Press the TIMER button on the remote control so that 0 or
R$C
disappears on the display.
T& restore the timer standby mode, press again to display ~ or
REC
Using the unit
while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone.
m
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the
built-in timer of this unit. Use an external timer.
TIMER RECORDING
Timer recording is applicable for TUNER and VI DEO/AUX (with
an external timer) sources only.
Press the TIMER button twice on the remote control so that
,9 appears on the display, and press the II SET button within
4 seconds. Repeat the steps in page 54 from step 2 and insert
the tape to be recorded into deck 2 after step 5.
SETTING THE SLEEP TIMER
The unit can be turned off automatically after a specified time
passes.
Use the remote control.
7
Press the SLEEP button.
"SLEEP" @ lights up, and SLEEP @ is displayed for 4
seconds.
2 Within 4 seconds. press the <
or *
button to
specify the time until the power is turned off.
Each time the button is pressed, the time changes between
10 and 240 minutes in 10-minute steps. The specified time
@is displayed.
To check the time remaining until the power is turned off
Press the SLEEP button once. The remaining time is displayed
for 4 seconds.
To cancel the sleep timer
Press the SLEEP button twice so that "SLEEP" on the display
disappears.
Tabla de contenido
loading

Este manual también es adecuado para:

Nsx-v51gNsx-v52Nsx-v54

Tabla de contenido