Automatic Flash Mode - Metz MECABLITZ 58 AF-2 digital Manual De Instrucciones

Group B:
• Matrix-controlled fill-in flash mode.
• Settings made on flash unit.
• Display on flash unit after saving:
Group C:
• 3D multi-sensor fill-in flash mode.
• Settings made on flash unit.
• Display on flash unit after saving:
Group D:
• D-TTL 3D flash mode.
• Settings made on flash unit.
• Display on flash unit after saving:
Group E:
• i-TTL BL flash mode (not with Coolpix cameras).
• Settings made on flash unit.
• Display on flash unit after saving:
Some cameras do not support TTL fill-in flash mode in combination with
SPOT exposure metering. This flash mode will then either be automati-
cally cancelled or cannot be activated in the first place. In this case, nor-
mal TTL flash mode, D-TTL or i-TTL modes will be set (see camera's opera-
ting instructions).
TTL
BL
TTL
BL
TTL
BL
TTL
BL

5.4 Automatic flash mode

In the automatic flash mode A, the flash unit sensor measures the light that
reflects back from the subject. The sensor has a coverage of about 25°, and
only measures the light for the time a flash is fired by the mecablitz. The flash is
cut off as soon as sufficient light has been emitted for correct exposure. The sen-
sor of the mecablitz has to be directed at the subject.
The maximum range is shown on the LC display. The shortest shot distance is
approximately 10% of the maximum distance range. The subject should be loca-
ted within the middle third of the distance range shown on the LC display to
allow the electronic system sufficient leeway for compensation.
Setting procedure:
• Press the Mode button until „Mode" flashes on the
LC display.
A
• Set the flash mode using the
arrows. The flash mode selected is then highlighted.
The setting takes effect immediately.
• Press the button to change the LC display back
to the normal view. If the button
the display will change back to the normal view after
about 5 seconds.
If the shot was properly lit, the correct exposure indica-
tion will flash „OK" for about 3 seconds (see 13).
TTL BL
Mode
A A
M
Set
and
A F 4.5
AZoom 70
is not pressed,
14 m ISO 200
Mode Para Sel
121