Milwaukee 2774-20 Manual Del Operador página 8

8. Press the retract button
for one second.
Light
Indicator
Solid Green Tool reached full pressure.
Solid Red Tool did not reach full pressure.
Continuous Tool has reached its service interval
Flashing (20,000 crimps). Red/Green flashing
Red/Green will begin after the solid Red or Green
indicator for the operation is displayed.
(after Solid
MILWAUKEE recommends that the
Green or
tool be inspected and preventative
Solid Red)
maintenance completed. Return tool to
a MILWAUKEE service facility.
Short Tool has malfunctioned and can no
Flashing longer be used until it is turned in for
Red/Green service. Return tool to a MILWAUKEE
service facility.
NOTE: If the indicator shows red, check the oil levels
and ensure that no leaks are happening in the at-
tachments. Confirm that all connections are secure
and the attachments are proper for the job. Operate
again. If the problem persists, return the tool to a
MILWAUKEE service facility.
To operate in Wireless mode:
1. Depressurize the tool by holding down the manual
pressure release button for five seconds.
2. Connect the hose coupler to the pump coupler.
3. Connect the tool head to the hose.
4. Insert the battery pack.
5. Disconnect the remote from the cable and remove
it from the pump.
6. Press the wireless mode
button on the pump.
The beacon light will flash
red.
7. On the remote, turn the
wireless power switch
on .
The bluetooth light will
flash blue, then turn
solid when connected.
Once connected, light 1
will flash red.
1
sec
Definition
8. Press and hold the ad-
vance button
proximately three sec-
onds.
Light 1 will turn steady
red.
Release the advance
button .
Light 2 will flash red.
NOTE: This step must be done within five minutes
of activating wireless mode. WARNING! Once the
pump is started using wireless mode, it will run to
completion and cannot be halted.
9. Press and hold the re-
tract button
proximately three sec-
onds.
Light 2 will turn steady
red.
Release the retract but-
ton . Initiation will be-
gin.
NOTE: This step must be done within twenty seconds
of the advance button
10. When the cycle is com-
plete, the pressure
indicator will light:
Green (right) =
Full pressure
reached
Red (left) =
Full pressure NOT
reached
Light
Indicator
Solid Green Tool reached full pressure.
Solid Red Tool did not reach full pressure.
NOTE: If the indicator shows red, check the oil levels
and ensure that no leaks are happening in the at-
tachments. Confirm that all connections are secure
and the attachments are proper for the job. Operate
again. If the problem persists, return the tool to a
MILWAUKEE service facility.
8
for ap-
for ap-
being pressed.
Definition
3
sec
3
sec