Functional Description And Specifications - stayer MULTI DRILL 130 Manual De Instrucciones

1.- Functional Description and Specifications

Disconnect the plug from the power source before making any assembly, adjustments or changing
WARNING
!
accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
HOUSING CAP
COLLET
COLLET
NUT
2.- Assembly
Always unplug Rotary Tool before
WARNING
!
changing accessories, changing collets
or servicing your Rotary Tool.
COLLET
WRENCH
TO
TIGHTEN
COLLET NUT — To loosen, first press shaft lock button and
rotate the shaft by hand until the lock engages the shaft
preventing further rotation.
Do not engage lock while the Rotary Tool
CAUTION
!
is running.
With the shaft lock engaged use the collet wrench to loosen
the collet nut if necessary. The collet nut must be loosely
threaded on when inserting an accessory. Change
accessories by inserting the new one into the collet as far as
possible to minimize runout and unbalance. With the shaft
SHAFT LOCK
BUTTON
VENTILATION
OPENINGS
SHAFT
LOCK
BUTTON
COLLET
TO
NUT
LOOSEN
ENGLISH
15
BRUSH COVER
(one on each side)
VENTILATION
OPENINGS
MULTI DRILL 130
Rated power input
No-load speed
Collet capacity
Weight
These data are valid for nominal voltages of [U] 230/240 V ~ 50/60 Hz – 110/120
V ~ 60 Hz. These values may change of the voltage was lower and in the specific
embodiments for certain countries.
lock engaged, finger tighten the collet nut until the
accessory shank is gripped by the collet. Avoid excessive
tightening of the collet nut when there is no bit inserted.
COLLETS — Four different size collets (see illus tration), to
accommodate different shank sizes, are avail able for your
Rotary Tool. To install a different collet, remove the collet nut
and remove the old collet. Insert the unslotted end of the
collet in the hole in the end of the tool shaft. Replace collet
nut on the shaft.
Always use the collet which matches the shank size of
the accessory you plan to use. Never
CAUTION
!
force a larger diameter shank into a collet.
Note: Most rotary tool kits do not include all four collets
sizes.
COLLET IDENTIFICATION CHART
Collet sizes can be identified by the rings on the back end of
collet.
1/32" Collet has one (1) ring.
1/16" Collet has two (2) rings.
3/32" Collet has three (3) rings.
1/8" Collet has no rings.
(Included in most tool kits on the tool)
15
SPEED
REGULATOR
CORD
HANGER
SWITCH
W
-1
8.000 - 33.000
min
1 - 1.6 - 2.4 - 3 - 3.2 mm
ø
kg
130
0.5