Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Part names and functions
Overall diagram
2
1
2
3
4
5
6
Power dial
1
Controls power to the unit.
Dual start/stop buttons
2
Engages and disengages the motor/platter.
Platter speed buttons
3
Select 33 or 45 RPM platter speed. 78 RPM is selected by pressing
both the 33 and 45 buttons simultaneously; both buttons should
be illuminated.
Platter
4
Cast aluminum platter mounts directly to center spindle/motor shaft.
Strobe dots (on platter edge)
5
Operate in conjunction with stroboscopic light located under the
power dial to provide visual indication of accurate platter speeds.
Spindle
6
Removable stylus target light
7
Provides illumination directed at the stylus position for easier
cueing in low light. Easily plugs into jack on top of turntable deck.
Start control knob
8
Rotate the start control knob to increase or decrease platter start
time between 0.2 – 6.0 seconds. (Minimum setting is the quickest
start; maximum setting is the slowest start to reach selected speed.)
Brake control knob
9
Rotate the brake control knob to increase or decrease platter brake
time between 0.2 – 6.0 seconds. (Minimum setting is the quickest
stop; maximum setting is slowest.)
Reverse control button
10
Controls platter's rotational direction.
14
13
12
7
8 9
10
11
15
16
17
18
Speed range button
11
Select +/- 10 or 20% speed range.
• +/-50% is selected by pressing both the 10 and 20 buttons
simultaneously.
Quartz button
12
Turns the pitch function on and off. When the quartz is activated
the platter will hold the RPMs at 0% pitch, regardless of the pitch
slider position and speed range control settings.
Pitch adjust slide control
13
Use in conjunction with pitch button to vary the platter's rotational
speed. In the center detent position quartz lock is active.
45-RPM adapter
14
Adapt 7" records with large center holes to fixed center spindle
Feet
15
Adjust the level of the product.
Stereo output terminals
16
Connect the RCA audio cable. Connect it to either the amplifier's (DJ
mixer's) PHONO input jack or its line input jack. The red terminal is
the right channel and the white terminal is the left channel.
Ground (earth) terminal
17
Connect the amplifier's ground (earth) terminal to this terminal
using the RCA audio cable's ground line.
Pre-amplifier selector switch
18
If connecting to an amplifier's (DJ mixer's) PHONO input jack, set
this switch to the PHONO position. If connecting to the LINE/AUX
jack of an amplifier (DJ mixer), set this switch to the LINE position.
USB output
19
Use this output to connect your turntable to the USB input of your
computer.
AC inlet
20
Use to connect the included power cable.
19
20
15
E
N
4
Tabla de contenido
