Securing The Unit To The Wall; Deciding The Position; Deciding The Wiring Route; Front View - PowerStar AE 3.4 Instrucciones De Instalación Y Funcionamiento

Installation
4.5

Securing the unit to the wall

4.5.1

Deciding the position

B If being used in a public place, position the unit out of
reach to discourage vandalism.
B Mount the unit onto a flat section of wall, well away
from any potential splashes of water or spray.
Cold
Fig. 6 Examples of installations
4.5.2

Deciding the wiring route

You have a choice of whether to feed the electric cable
through the cover bottom or through the back of the
unit,
B If it is going to be through the cover bottom, cut out
the plastic lug to expose the rubber sleeve (Fig. 7):
Fig. 7 Cover lug cut out
B If it is going through the back of the unit, cut through
the grommet on the backplate with a sharp knife.
Make sure that you do not remove the grommet from
the backplate (Fig. 8):
12
Cold
Hot

Front view

B Mount only as shown in Fig. 6 with the water
connections located either at bottom or the right side
of the unit.
Remember to keep the lengths of hot water pipe to a
minimum in order to save energy.
B If the unit is to supply a sink, you can fit it either above
or below the sink.
Hot
Hot
1
Fig. 8 Back of unit
1 Grommet
2 Fixing holes
B Feed the cable through the grommet before you
mount the unit to the wall. If you are using an
approved cable fitting, remove the grommet.
4.5.3

Mounting on the wall

B Undo the retaining screws on the cover and take the
cover of the unit. Hold the backdate in position
against the wall while you mark the four mounting
holes.
Cold
2
6 720 800 537 (2011/09)