Audiovox NAV3000 Instrucciones De Manejo Y De Montaje página 48

MOUNTING INSTRUCTIONS
Completing electrical connections, ill. 12
Lay all cables carefully. Refer to the connecting diagram on the fold-out page at the
end of the booklet and to the table below.
Power supply cable 6 (ISO connector A):
Pin no. Cable color
A1 black/white
A2 white/yellow
A3 white/brown
A4 red
A7 violet
A8 brown
A
Only connect electrical signals to appropriate terminals in the vehicle.
A
In the case of a direct connection to the battery secure the positive connection (red
lead) with a 10 A fuse close to the battery (max. 4 - 6 inches).
1. Connect the free cable ends A4, A7 and A8 of the power supply cable 6 to suitable
terminals in the vehicle according to the connecting diagram and the table.
2. Do not cut off unused cables! Wind them together and tie them back! They may be
used later to install additional features.
Speedometer signal (ISO connector A):
Connect the black/white cable A1 from cable harness to the tapping position of the
speedometer signal.
Note: Many cars are supplied with the speedometer signal on one of the car radio
connectors. Ask your car dealer for more information.
A
Never tap the speedometer signal from the ABS control!
Further signals (ISO connector A):
Connect the white/yellow cable (A2) to a suitable connecting point of the back up
lights (positive pole of the reversing lamp).
Connecting system components (ISO connector B):
Connect the plug of the remote control cable to the socket on the signal cable
harness 5.
Connect the loudspeaker (accessory) with the 3.5 mm jack to the 3.5 mm plug of the
signal cable harness 5.
The loudspeaker impedance should be between 4 and 8 Ohms.
48
Connection
speedometer signal input
back-up lights (reversing signal)
mute signal output (open collector)
+12V permanent power supply (via cable fuse 10 A if necessary)
+12V switched (must not be interrupted during engine start)
negative battery pole